To Next Page

To Previous Page

E - 4 BeneVision N Series Patient Monitor Operator’s Manual

E.8 Patient Auxiliary Current

Patient Auxiliary currents are measured between any selected Applied Part connector and the remaining

Applied Part connector s. All measurements may have a true RMS only response.

The following outlet conditions apply when performing the Patient Auxiliary Current test.

■ normal polarity (Normal Condition);

■ reverse polarity (Normal Condition),

■ normal polarity with open neutral (Single Fault Condition);

■ reverse polarity with open neutral (Single Fault Condition).

■ normal polarity with open earth (Single Fault Condition);

■ reverse polarity with open earth (Single Fault Condition).

LIMITS

For CF applied parts,

◆ 10 A in Normal Condition

◆ 50 A in Single Fault Condition

For BF applied parts,

◆ 100 A in Normal Condition

◆ 500 A in Single Fault Condition

NOTE

• Make sure the safety analyzer is authorized comply with requirement of IEC60601-1.

• Follow the instructions of the analyzer manufacturer.

Mindray BeneVision N19 User Manual

Other manuals for Mindray BeneVision N19