10-16 Patient Data Management
Delete a User
Premise: you must log on the system as the system administrator. If not, you will be required to
enter administrator name and password before the setting.
1. Open the ―Admin‖ page through the path: [Setup]→[System]→[Admin].
2. Select the user to be deleted in the User List, click [Delete] to delete the selected user.
10.9.5 Modify Password
The system administrator can modify password of all users. The administrator password by factory
is empty; you can set the password for it.
The operator can only modify his/her own password. There are two ways to modify password:
modify it on ―Admin‖ page or on ―Session Manage‖ dialogue box.
―Admin‖ page (administrator can modify the password)
1. Open the ―Admin‖ page through the path: [Setup]→[System]→[Admin].
2. Select the user name to be modified in User List, click [Change Password] to open the
dialogue box (see the figure below).
3. Enter new password and confirm the password, then click [OK].
Session Manage page (general operator and administrator can modify the password).
When the user has logged on the system, you can see at the lower right corner of the
screen.
1. Click at the lower right corner to pop up the Session Manage dialogue box, on which you
can see the current user’s information.
2. If you want to modify the current password, click [Change Password] to pop up the Change
Password dialogue box.
3. Enter the previous and the new password in the dialogue box.
4. Click [OK] to exit.
To Next Page
Loading...
Need help?
General
