17-4 System Maintenance
Cleaning the main panel
Tools: dry soft cloth, soapy water
Method:
Use dry soft cloth to clean the surface of control panel (including keystrokes, encoders and
sliders). If the control panel is dirty, moisten the soft cloth with a little mild soapy water and
wipe off any stains. Use another dry soft cloth to remove any moisture and allow all hard
surfaces to completely air-dry. If it is difficult to clean the control panel, disassemble the
encoder caps first and then use mild soapy water to clean it.
Keyboard on the control panel should be cleaned periodically; otherwise, keys maybe
blocked by dirt and buzzer dings, keys don’t work.
Cleaning cover
Tools: dry soft cloth, soapy water
Method:
Use dry soft cloth to clean the cover of the system. If the system is dirty, moisten the soft cloth
with mild soapy water and wipe off any stains, then air-dry.
Clean dust-proof cover
Tool: Soft brush
Method:
a) Disassemble dust-proof cover before cleaning.
System dust-proof cover: Grab the lower side of the dust net frame, and then pull out the
net.
Probe port dust-proof cover: there are 4 probe ports at the front of the system, on which
there is a dust-proof cover. Pull it out.
b) Cleaning: with soft brush and then wipe off the dust.
c) Assemble dust-proof covers.
Input the dust-proof clasp into the slot of the main unit, push the dust-proof inward until
the dust-proof clasp is stuck in the slot.
Please clean all dust-proof covers of the system periodically (1 time
per month); otherwise, system damage may result. Cleaning times can
be increased when the system is used in the open air or somewhere
dust is more.
To Next Page
Loading...
Need help?
General
