iWorks (Auto Workflow Protocol) D-5
D.8.3 Create New Protocol
You can create user-defined protocols and customize the automated procedure.
1. In the iWorks preset screen, click [Add Protocol] to create a new protocol, enter the protocol name,
type and select the application region.
Or you can select an existed protocol and click [Copy] to customize the protocol based on the
previous template.
2. Click [Add View] to enter the view name, and perform image settings, as shown in the following
figure.
3. Perform comments, body mark, measurement settings, as shown in the following figure:
To Next Page
Loading...
