S-3
6． No waterproof device is applied to the system. Do not use the
system in any place with the possibility of water ingress. There is
risk of electric shock if any water is sprayed on or into the system.
If you carelessly spray any water onto/into the system, contact the
Mindray sales office, customer service department or
representative.
7． Use the transducer carefully. In case that the human body contacts
the scratched transducer surface, immediately stop using the
transducer and contact the Mindray sales office, customer service
department or representative. There is risk of electric shock if using
the scratched transducer.
8．Be careful not to let the patient contact the ultrasound equipment. If
the ultrasound equipment is defective, there is risk of electric
shock.
9. Do not use the transducers other than those provided by Mindray. If
a transducer other than those provided by Mindray is connected,
the equipment and the transducer may be damaged, causing an
accident such as a fire in the worst case.
10. Do not subject the transducers to knocks. Use of defective
transducers may cause electric shock.
11. Do not open the shell or panel. If open the shell when the equipment
is powered on, there may be a short circuit or electric shock.
12. Do not use the equipment at the same time use equipment such as
an electric scalpel, high-frequency therapy equipment or a
defibrillator, etc.
13. Precautions during transportation: When moving the equipment,
hold the handle. If the user holds other sections, the equipment
may be subject to unnatural force and may be damaged. Do not
move the equipment in the left/right direction. If the equipment is
moved in the left/right direction, the equipment may fall.
14. Accessory equipments connected to the analogue and digital
interfaces must comply with relevant IEC standards. Furthermore
all configurations should comply with the standard IEC60601-1-1.
Everybody who connects additional equipments to the signal input
part or signal output part configures a medical system, and is
therefore responsible that the system complies with the
requirements of IEC60601-1-1. If in doubt, consult Mindray
customer service department or your local distributor.
To Next Page
Loading...
Need help?
General
