EasyManua.ls Logo

Minelab CTX 3030 - Recharge the Li-Ion Battery Pack with the Car Charger

Minelab CTX 3030
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
small light on the car charger illuminates
indicating that the car charger is in
operation.
4. Leave for 18 hours to fully recharge. If the
battery was not completely discharged,
the charging time will be shorter.
5. Some vehicles may require the ignition to
be switched on to ‘Accessories’ for power
to be supplied to the charger.
6. Charging the battery for longer than 18
hours will not damage the Li-ion battery
pack. However, it may gradually discharge
your car battery.
NOTE
The car charger is provided with a fuse
for short circuit protection. The fuse can
be accessed by unscrewing the tip of the
charger plug.
capacity after several charge/discharge
cycles.
5. Once charged, disconnect the plug pack
and remove the battery pack from the
charger.
NOTE
For best results, the battery pack must be
recharged whenever the detector has been
unused for a long period of time.
Recharge the Li-ion Battery Pack
with the Car Charger
1. Remove the battery pack.
2. Insert the car charger plug into the
accessories socket of your vehicle.
3. Insert the car charger plug into the socket
at the tapered end of the battery pack. A
The Lithium-ion battery is specically
designed for the CTX 3030 and is
not compatible with non-CTX 3030
detectors. Attempting to use the
Lithium-ion battery pack with other
detectors may damage the detector or
the battery pack. Do not try to adapt
this battery to other models as it will
very likely cause damage.
Do not charge the battery at
temperatures above 45°C (11F) or
below C (32°F).
Do not immerse the battery in any
liquid or allow water ingress.
Do not leave the battery in hot
conditions (e.g. on the dashboard of
your car or rear parcel shelf ).
Do not throw the battery or impact it in
any way.
Do not short-circuit the battery.
Do not use the battery if it is damaged
or deformed.
Do not disassemble or reconstruct the
battery.
Do not incinerate the battery.
In the event of a fault, return the battery
to a Minelab authorised service centre
for repair. The use of non-approved
components will VOID YOUR WARRANTY.
There are no user serviceable parts
within this battery pack.

Related product manuals