Minelab CTX 3030 - Turn.on.and.go; Power Button

14
Turn On and Go
Power Button
Short Press: On/O
Long Press: Factory Preset
Press the Power button once to turn the
detector on.
The detector will begin with an animation
and tune, after which the Smartnd
Detect screen will appear and CTX 3030 is
ready to nd treasure!
NOTE
On initial startup only, the detector will
begin with an animation and tune, after
which you will be prompted to select your
preferred language before proceeding to the
Smartnd Detect screen.
It is best to operate the detector only
when outdoors and away from sources
of electromagnetic interference (EMI)
such as power lines and phone towers.
These sources may cause the detector to
perform erratically, giving false signals and
causing inaccurate target ID.
There are also many metallic objects
inside a house, such as nails in the oor,
reinforcing in the walls, televisions and
other household appliances, that might
overload the electronics of the detector.
Overloading is not harmful to the
electronics of the detector. CTX 3030 is
designed to withstand coil overload.
NOTE
Sometimes it is possible that a large object
close to the coil will overload the detector’s
electronics. When this happens, CTX 3030
displays an Overload message and emits a
fading Overload sound which repeats until
the coil is moved away from the source of
the overload.
Each time you turn the detector on, the
last detection screen used before shutting
down will appear. For example, if CTX
3030 was operating in the Smartnd
Detect screen when turned o, this screen
will appear when CTX 3030 is turned back
on.
Press the power button to turn the
detector o.