The Minelab Sovereign ElitePage 6
j) Turn the Disc control progressively clockwise in steps and pass the
coil over the objects. Take note of when certain objects are rejected,
this will enable more accurate discrimination of these objects in the
field.
k) Turn the Disc control to the position where it ignores the
pull-tab. Passing the coil over objects with lower conductivity (such as
the aluminium foil) will not produce a signal. Take note of the
threshold tone as it disappears and then returns again. It should
return at a slightly different pitch than normal. This indicates that the
Sovereign Elite ignored a non-ferrous object.
l) Turn the Disc control back to the most anti-clockwise position.
m)Progressively turn the Notch control in a clockwise direction, again
passing the coil over the test objects. The Notch control enables the
detector to ignore a small number of objects with similar conductivity
while still detecting other valuable non-ferrous objects, even if they
are of lower conductivity.
n) Turn the Notch control to ignore the pull-tab. Objects with similar
conductivity to the pull-tab will be ignored. Pass the coil over the
aluminium foil and the Sovereign Elite will produce a signal. This would
not be possible using the Disc control.
o) Turn the Disc control to ignore the aluminium foil.
The Sovereign Elite is now set to ignore the types of objects most
commonly unwanted by treasure hunters.
To Next Page
Loading...
Need help?
General
