7
CONTENTS
Beep!
Pinpoint
LOCATE A TARGET
Once a target has been detected, the manual pinpointing
technique locates the exact position before digging� This
means less digging, and faster recovery of the target�
1� Sweep the coil slowly across the target location keeping
the coil parallel to the ground�
2� Locate the centre of the target by listening for the loudest
target signal response�
3� Make a mental note of the position, or mark a line on the
soil with your shoe or a digging tool�
4� Move to one side so that you can pass the coil over the
target at right angles to your initial direction�
5� Repeat steps 1 and 3 from your new position� The target is
located where the two imaginary lines cross�
Beep!
Make a line where the
strongest signal is heard�
Stand at right‑angles to
your initial position and
repeat�
The intersection of the
two lines marks the exact
location of the target�
1‑3
4‑5
Depth Gauge
The Depth Gauge indicates the approximate depth of a
detected target�
The Depth Gauge is a guide only� Fewer arrows indicate a
shallower target, more arrows indicate a deeper target� The
accuracy can vary depending on the target type and ground
conditions�
After a target is detected, the Depth Gauge will remain on the
LCD for up to 5 seconds, or until the next target is detected�
When there is no detection, the Depth Gauge icon and arrows
are turned off�
Here is an example of the Depth Gauge reading and the
approximate target depth for a US quarter�
50mm
2"
100mm
4"
150mm
6"
>150mm
>6"
To Next Page
Loading...
Need help?
General
