MINIWARE DT71 - Restore Factory Setting

» Restore Factory Setting
Open the CAL.INI config file, delete all data, enter “load default” and save it to restore
the factory settings.
» User-Defined Wave Setting
USER WAVEFORM ={
Ox7FF, Ox87F, OX8FF, Ox97E, OxX9FC, OxXA77, OXAFO, OxB66, OxXBD9, OxC 48,
OxCB2, OxD18, OxD 78, OxDD5, OxXE29, OxE 77, OXECO, OxFO1, OxF5C, OxF6F,
OxF9A, OXFBE, OXFDA, OXFEE, OxXFFA, OXFFE, OxXFFA, OxXFEE, OxXFDA, OXFBE,
OxF9A, OXF6F, OxXF3C, OXFO1, OXECO, OxXE7 7, OxXE29, OxDD3, OxD78, OxD18,
OxCB2, OxC48, OxBD9, OxXB66, OXAFO, OxXA 77, OxX9FC, Ox97E, OxX8FF, Ox87F,
Ox7FE, Ox77E, OX6FE, Ox67F, Ox601, Ox586, Ox5OD, Ox496, Ox424, Ox5B5,
Ox54B, OX2E5, 0Ox285, Ox22A, Ox1D4, Ox186, Ox13D, OXOFC, OXOCT, Ox0BE,
Ox0653, OxO3F, Ox025, OxXOOF, Ox003, Ox00O, Ox003, OxXOOF, Ox025, OxO3F,
Ox065, OxXOB8BE, OxXOCT, OxXOFC, Ox135D, Ox186, Ox1D5, Ox22A, 0x285, OX2E5,
Ox54B, 0Ox5B5, Ox424, Ox497, Ox5OD, Ox586, OxX601, Ox67F, OX6FE, Ox7 7E,
Ox000, Ox000, Ox00O0, Ox00O, Ox0O0OO, Ox00O, Ox00OO, Ox00O, Ox00O, Ox00O0O,
Ox000, Ox000, Ox00O0, Ox00O0, Ox00O, Ox00O, Ox00O, Ox00O, Ox00O, Ox00O,
Ox000, Ox000, Ox000, Ox00O, Ox000, Ox000, Ox000, Ox000, }
Note:
1) Use hexadecimal number Ox000-OxFFF to represent 0-3V signal waveform;
2) The output waveform only loads the first 100 points of valid data; red font
modification is invalid.