EasyManuals Logo

MINN KOTA RIPTIDE POWERDRIVE Installation Guide

MINN KOTA RIPTIDE POWERDRIVE
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
^ Not shown on Parts Diagram.
This part is included in an assembly and cannot be ordered individually.
♦ Only available with models factory installed with i-Pilot or i-Pilot Link.
•Only available with models factory installed with CoPilot.
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the centerline of the boat as possible. Make sure the area under the mounting location is clear to drill holes and
install nuts and washers. Make sure the motor rest is positioned far enough beyond the edge of the boat. The motor must not encounter any obstructions as it is lowered
into the water or raised into the boat when stowed and deployed. Consider a quick release or adapter bracket with the installation of your motor. To view a list of
accessories, please visit minnkotamotors.com.
View accessories available for your
trolling motor at minnkotamotors.com.
HTTP://DELIVR.COM/2M9WS-QR
TOOLS AND RESOURCES REQUIRED
#3 and #2 Phillips Screw Driver
Drill
9/32” Drill Bit
7/16” Box End Wrench
A second person to help with the installation
1
a. Place the mount on an elevated, level surface such as a workbench or the tailgate of a pickup. The motor, as removed from the box, should be in the stowed position.
b. Remove the four side plate screws using a #3 or #2 Phillips screwdriver. Two of these screws will be located on each side of the mount.
NOTICE: This motor weighs approximately 30 lbs. We recommend having a second person help with the installation.

Other manuals for MINN KOTA RIPTIDE POWERDRIVE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MINN KOTA RIPTIDE POWERDRIVE and is the answer not in the manual?

MINN KOTA RIPTIDE POWERDRIVE Specifications

General IconGeneral
Water TypeSaltwater
Speed ControlVariable
Digital MaximizerYes
i-Pilot LinkOptional
Speed SettingsVariable
WeightVaries by model
Voltage12V, 24V
Shaft Length48", 54", 60"
Control TypeFoot Pedal, i-Pilot, or i-Pilot Link
SteeringElectric Steering
Mounting LocationBow
Battery Requirement12V or 24V Deep Cycle Marine Battery
Motor TypeElectric
Warranty2 years
Thrust55 lbs
i-PilotAvailable on select models

Related product manuals