OPERATION
5
TO STOW:
Push down to release tilt lock lever
and raise the motor by pulling up
on the composite shaft or control
head. Pull the motor toward the
stern until it rests securely on the
ramp and the Grip Glide Lever
captures the collar.
TO DEPLOY:
Push firmly down on the Grip Glide
lever to release the collar and slide
the motor forward, out from the
ramp. Lower the motor to the
desired depth. Make sure it clicks
into a secure, vertical position.
TO ADJUST DEPTH:
Firmly grasp and hold the composite shaft
above the PowerDrive housing. Loosen
the depth/drive collar knob until the shaft
slides freely. Raise or lower the motor to
the desired depth. Tighten the
depth/drive collar knob to secure the
motor in place.
TO ADJUST LATCH COLLAR:
The latch collar is adjustable. If needed, loosen the Phillips head screw and rotate the collar up or
down to re-align the latch and collar. The ideal adjustment is a slightly loose fit that completely
captures the collar.
WARNING: WHEN RAISING OR LOW-
ERING MOTOR, KEEP FINGERS
CLEAR OF ALL HINGE AND PIVOT
POINTS AND ALL MOVING PARTS.
Grip Glide Lever
Tilt Lock lever
TECHNICAL ASSISTANCE
Do not take your CoPilot receiver or remote to your dealer or to a Minn Kota Authorized Service Center for repair or
replacement. The CoPilot remote has no field replaceable or user serviceable parts, (other than battery replacement).
For service/technical assistance call 1-800-227-6433, or send the CoPilot receiver and remote(s) along with proof of
purchase date to: Johnson Outdoors- MinnKota Service, 121 Power Drive, Mankato MN 56002-8129
FREQUENTLY ASKED QUESTIONS
Q. Are there any on/off switches?
A. No. The receiver is always powered up whenever the motor is connected to the battery or batteries. The remote
automatically goes into a low power “sleep mode” whenever there are no buttons being pressed.
Q. Does the remote float?
A. The remote will float by itself.
Q. Can other CoPilot users control my CoPilot if they get too close?
A. No. Each remote has it’s own unique ID number , your CoPilot receiver will not respond to commands from other
“unlearned” remotes.
Q. How many remote ID numbers can my receiver “learn”?
A. 10
Q. What happens if my receiver has 10 different remote ID numbers “learned” and I attempt to “teach” it another one
?
A. The first remote ID number that was learned will be erased (first in, first out).
Q. Can I turn the AutoPilot function on and off using CoPilot?
A. No. CoPilot only controls those functions that are available on the foot pedal.
Q. How long should the battery in the remote last?
A. Under normal use and conditions, the battery should last for at least two regular fishing seasons.
Q. Where can I purchase additional remotes and rod mounting brackets?
A. Through any regular Minn Kota retail outlet.
TECHNICAL ASSISTANCE FREQUENTLY ASKED QUESTIONS
16
To Next Page
Loading...
