EasyManuals Logo

MINN KOTA Riptide Ulterra User Manual

MINN KOTA Riptide Ulterra
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
52 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
FCC COMPLIANCE
FCC COMPLIANCE
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received, including interference that may cause undesired operation.
Changes or modifi cations not expressly approved by Johnson Outdoors Marine Electronics, Inc. could void the user’s authority to
operate this equipment.
INDUSTRY CANADA COMPLIANCE
This product meets the applicable Industry Canada technical specifi cations. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Changes or modifi cations not expressly approved by Johnson Outdoors Marine Electronics, Inc. could void the user’s authority to
operate this equipment.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Ambient operating temperature range: -10C to 50C
Ambient operating humidity range: 5% to 95%
Maximum operating altitude: 10,000 feet
ENvIRONMENTAL RATINGS
ULTERRA COMPLIANCE
i-Pilot Equipped Motors
• IC: 4397A-ULTERRAIP15
• FCC ID: T62-ULTERRAIP15
i-Pilot Link Equipped Motors
• IC: 4397A-ULTERRA20
• FCC ID: T62-ULTERRA20
RADIO OPERATION
NON-EUROPEAN
Frequency band: 915 MHz to 921 MHz
Maximum RF power transmitted: 0 dBm
EUROPEAN
Frequency band: 864 MHz to 870 MHz
Maximum RF power transmitted: 0 dBm
CE MASTER USER MANUAL (FOR CE CERTIFIED MODELS)

Other manuals for MINN KOTA Riptide Ulterra

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MINN KOTA Riptide Ulterra and is the answer not in the manual?

MINN KOTA Riptide Ulterra Specifications

General IconGeneral
Auto Stow/DeployYes
Power TrimYes
Saltwater UseYes
Blade MaterialComposite
Deploy/StowAutomatic
Spot-LockYes
Thrust80 lbs
Voltage24V
Shaft Length45"
i-Pilot LinkYes
i-PilotYes
Remote ControlWireless

Related product manuals