Minolta 5600HS (D) - Using Two Flash Units Wirelessly; Setting Up Two Flash Units as Controller; Setting Up Off-Camera Flash

4948
5. Press the select button repeatedly
until blinking stops.
6. Attach the 5600HS (D) to the camera.
WIRELESS/REMOTE FLASH MODE
• The 5400HS or 5400xi may be used as the controller. See the flash
unit manual if using the 5400HS. Display [W.L - C.1] if using the
5400xi.
Setting Up The Off-Camera Flash
(The following applies when the 5600HS (D) is used as the off-cam-
era flash.)
1. Switch the 5600HS (D) on.
2. Press the mode button to display
or .
3. Press the select button repeatedly to
blink [WL].
4. Press the + or – button to blink [WL
On].
5. Press the select button repeatedly
until blinking stops.
• The 5400HS, 5400xi, or 3500xi may be used as the off-camera flash.
See the flash manual if using the 5400HS. Display [W.L-F.1] if using
the 5400xi. Press and hold the on/off button until wireless indicator
glows if using the 3500xi.
[2]-1 Using Two Flash Units
• Use two 5600HS (D), 5400HS, or
5400xi, or one 5600HS (D), 5400HS,
or 5400xi, and one 3600HS (D) or
3500xi.
• Use Maxxum/Dynax 9, 7, 800si, 700si,
or 600si.
When two flash units are used, the
unit attached to the camera is used as
the controller, and the other as the off-
camera flash.
+ button
– button
Select button
Mode button
Setting Up The Controller
(The following applies when the 5600HS (D) is used as the con-
troller.)
1. Switch the 5600HS (D) on.
2. Press the mode button to display
.
3. Press the select button repeatedly to
blink [WL].
4. Press the + or – button to blink [WL
CONTROL].
Continued on next page
WIRELESS FLASH