5958
• When the power level is changed, the distance displayed on the data
panel changes accordingly.
• Power level settings can be set independently for TTL photography
, manual flash photography , and multiple photography
. When switching between these, the flash will remember your
setting for each individual mode.
• In TTL flash photography, the power level will be adjusted with the
selected level its maximum.
• In manual flash photography, if the power level is set at 1/1, then the
flash will fire at full power. If set at 1/2, it will fire at half power, etc.
SETTING POWER LEVEL (LEVEL)
The power level for the flash can be adjusted.
1. Press the select button to dis-
play [LEVEL] on the data
panel.
• The current level is displayed.
• This step may be ignored when man-
ual flash is selected.
2. Press the + or – button to
select the power level to be
set.
• With TTL or manual flash photogra-
phy the power level may be selected
from the following.
1/1, 1/2, 1/4, 1/8, 1/16, 1/32
• With multiple flash photography the
power level may be selected from the
following.
1/8, 1/16, 1/32
3. Press the select button.
POWER LEVEL
To Next Page
Loading...
