6160
4. Press the + or – button to
select the flash frequency.
• The flash frequency may be selected
from the following.
100, 50, 40, 30, 20, 10, 9, 8, 7, 6, 5,
4, 3, 2, 1
• Press and hold the + or - buttons to
change the value rapidly.
5. Press the select button to blink
[TIMES].
• The current number of flashes for
multiple flash is displayed on the
data panel.
6. Press the + or – button to
select the number of flashes.
• The number of flashes may be
selected from the following.
--, 40, 35, 30, 25, 20, 15, 10, 9, 8, 7,
6, 5, 4, 3, 2
• Press and hold the + or - buttons to
change the value rapidly.
• When -- is selected flashes continue
at the set frequency while the shutter
is open.
Continued on next page
MULTIPLE FLASH (MULTI)
The flash is triggered a number of
times while the shutter is open.
Multiple flash allows motion of the
subject to be captured in a photo-
graph for later analysis.
• The camera must be set to the M
(manual) mode for multiple flash pho-
tography. Multiple flash cannot be
used unless the camera supports the
M mode.
1. Set the camera to the M mode.
2. Press the mode button to dis-
play of the data panel.
3. Press the select button to blink
[Hz].
• The current multiple flash frequency
(flashes per second) is displayed on
the data panel.
MULTIPLE FLASH
To Next Page
Loading...
