LCD Monitor - page 23
When the camera is turned on in Record Mode, the LCD monitor automatically turns on.
When the camera is changed to Record Mode from another mode, the LCD monitor
resumes the Record mode’s last ON/OFF position.
Burst Mode - page 31
Processing of a Burst Image series takes approximately three minutes. During this time,
another Burst series cannot be taken. However, the mode can be changed and Still images
can be taken.
Image Quality Default Settings - page 47
The default image quality setting for all image types (Still, Burst, and Timelapse) is
Standard (STD).
Bracketing Sequence - page 56
The exposure sequence for Bracketing is: under, normal, over.
Before starting a bracketing sequence, be sure the Busy lamp is not glowing. (Bracket oper-
ation is unpredictable if a series is started when the busy lamp is glowing.)
Formatting CompactFlash Cards - page 62
After formatting the CompactFlash card with the Dimâge EX, turn the camera off once, then
turn the camera on again.
Review Mode Display - page 74
The file name for uploaded images will not be displayed.
Custom Scripts - page 102
For details regarding the Digita Script software development kit, visit the FlashPoint
Technology home page at http://www.flashpnt.com/
• Depending on the contents of a specific script, certain scripts may cause instability in the
camera’s operation.
• Minolta is not responsible for the results of user-made custom scripts used with the Dimâge EX.
CompactFlash Card Maximum Capacity - page 105
It is recommended that the maximum number of images recorded on a CompactFlash card
in the Dimâge EX does not exceed 200. If more than 200 images are recorded on a
CompactFlash card in the camera, camera operation may be unpredictable.
IMPORTANT INFORMATION
This insertion contains important late-breaking information about the Dimâge EX and
included software. Please read this information carefully and review it with the proper
section of the appropriate instruction manual. Please register your software to
receive software upgrade information.
CAMERA INSTRUCTION INFORMATION
14
© 1998 Minolta Co., Ltd. under the Berne Convention and
Universal Copyright Convention
Printed in Japan
9229-2760-27 (P-B810)
Installation of QuickTime 3.0
QuickTime™ 3.0 is necessary to run the Digita Desktop™ software on the Macintosh.
Install QuickTime 3.0 if it is not already installed on your system.
1. Insert the Dimâge EX CD-ROM into the CD-ROM drive.
2. Double-click on the CD-ROM icon, then double-click on the QuickTime Installer folder.
3. Double click on the Installer icon in the QuickTime Installer folder.
4. Follow the instructions that appear on the screen.
SOFTWARE INFORMATION FOR MACINTOSH
To Next Page
Loading...
