76 77
DATA
-TRANSFER MODE
Choose the recommended search for a
suitable driver. Click “Next.”
Choose to specify the location of the dri-
ver. The browse window can be used to
indicate the driver location. When the
location is shown in the window, click
“Next.”
• The driver should be located in the CD-
ROM drive at :\Win98\USB.
Manual installation
To install the Windows 98 driver manually, follow the instructions in the connecting-the-
camera-to-a-computer section on page 73.
The add new hardware wizard will confirm
the location of the driver. Click “Next” to
install the driver in the system.
• One of three drivers may be located:
MNLVENUM.inf, USBPDR.inf, or
USBSTRG.inf.
• The letter designating the CD-ROM drive will
vary between computers.
The last window will confirm the driver has
been installed. Click “Finish” to close the
add new hardware wizard. Restart the
computer.
When the my-computer window is
opened, a new removable-disk icon will
be displayed. Double click on the icon to
access the camera’s memory card; see
page 80.
When the camera is plugged into the com-
puter, the operating system will detect the
new device and the add-new-hardware-
wizard window will open. Place the
DiMAGE software CD-ROM in the CD-
ROM drive. Click “Next.”
To Next Page
Loading...
Need help?
General
