3. Turn either control dial until the desired film speed setting appears in the
body data panel.
• Each click of the dials will change the film speed setting by 1/3-stop
between ISO 6 and 6400.
4. Press the ISO button again to enter your selection and return to operating
mode, or wait 4 sec. and the setting will be entered automatically.
• To check the film speed setting at any time during operation, press the
ISO button. The ISO-speed will appear in the body data panel
• For flash exposures, Minolta recommends that you use film between ISO
25 and 1000.
19
To Next Page
Loading...
