Manual Film Speed Setting
If you are using a non-DX-coded film or if you wish to override the
automatic setting, you must manually set the film speed. The camera will
initially set non-DX-coded film to the ISO of the previous roll; initially this
value is set to 100.
1. Load the film and close the back cover.
2. Open the card door and press the ISO button.
-NEXT PAGE-
18
If you use DX-coded film between ISO 25 and
5000, the camera will automatically set the
correct film speed. The film speed setting will be
displayed in the body data panel for 4 sec. after
you load the film.
Automatic Film Speed Setting
To Next Page
Loading...
