Minolta MNCD337N - 4.1.3 Exposure; 4.1.4 Motion Detection; 4.1.5 Beep Sound; 4.1.6 Collision Sensitivity

10
4.1.3 Exposure
This function adjusts the frame brightness in your video.
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Exposure’ by using the UP
or DOWN buttons. Press the OK button to enter the ‘Exposure’ submenu.
2. Press the UP or DOWN buttons again to navigate the submenu and select a setting. You
can select from +2.0, +5/3, +4/3, +1.0, +2/3, +1/3, +0.0, -1/3, -2/3, -1.0, -4/3, -5/3, and -
2.0.
3. Press the OK button to confirm your selected setting.
To exit the settings menu, press the MENU button and your camcorder will return to the
main status screen of the current mode.
4.1.4 Motion Detection
This setting automatically begins recording if movement is detected in front of the
camcorder lens. Once recording, the camcorder will stop recording if not further movement
is detected within a 10-second period of the last movement registered. You may also
manually stop recording anytime by pressing the OK button during a recording.
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Motion Detection’ by using
the UP or DOWN buttons.
2. Press the OK button to turn Motion Detection on or off, a check indicates that the option
is activated.
To exit the settings menu, press the MENU button and your camcorder will return to the
main status screen of the current mode.
Note: When selecting OFF, your camcorder will still automatically record upon startup if you
power it off.
4.1.5 Beep Sound
This setting allows you to enable or disable the sound when pressing a button.
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Beep Sound’ by using the
UP or DOWN buttons.
2. Press the OK button to turn Beep Sound on or off, a check indicates that the option is
activated.
To exit the settings menu, press the MENU button and your camcorder will return to the
main status screen of the current mode.
4.1.6 Collision Sensitivity
This setting allows you to set the sensitivity level for automatic recording upon collision.
When triggered or when the camcorder things a collision occurred, it will automatically