7
3. CAMCORDER OPERATION
Once you have inserted the MicroSD memory card and plugged your camcorder into a power
source, your camcorder will automatically power on. You may also manually power your
camcorder on or off by pressing the POWER button for 2 seconds.
There are 3 operation modes available for use. To cycle through the different modes, simply
short press the POWER / MODE button. Your camcorder creen will show the current mode
Modes cannot change while a video is being recorded.
The recording must stop first before changing to another mode.
3.1 Video Capture Mode
Once your camcorder powers on, it will default to Video Mode and will begin recording
automatically. To start or stop recording at any time, press the OK button. To manually
capture video when changing from another capture mode, enter VIDEO Mode and press the
OK button to begin recording video again. Press the UP button to change the view of the rear
camera.
3.2 Photo Capture Mode
To capture a photo, enter PHOTO Mode by short pressing the POWER / MODE button until a
camera icon is show in the upper left hand corner of the screen. Press the OK button to
instantly capture a photo. You may also capture a photo during a video recording by pressing
the UP button. To capture a photo of the view of the rear camera, press the UP button to
change the view to the rear camera then press the OK button to capture the photo.
3.3 Playback Mode
To review your video and photo files, enter PLAYBACK Mode. Short press the POWER /
MODE button until a previously captured file is shown on the screen. The most recent file
captured will be displayed first.
Press the UP and DOWN buttons to cycle through available playback files of photos and
videos.
To delete a file or to protect a file from deletion, press the MENU button.
Press the POWER / MODE button again to exit PLAYBACK mode.
Playing Back Video Clips
Press the OK button to play or pause a video clip in PLAYBACK mode.
To Next Page
Loading...
