Minuteman E26 - Filling the Solution Tank; Empty the Solution Tank; Cleaning Clear Water Filter

Page 29
5.5.1 Filling the Solution Tank
Fill solution tank (Fig. 8/1) before operation or as required.
Park vehicle on level ground. Open tank lid (Fig. 8/5)
and fi ll tank up to the maximum (1/1 marker) (Fig. 8/2).
Alternatively, fi lling of the machine via quick coupling (Fig.
8/6) is available. Before doing so, connect the fi lling hose
of the metering unit to the quick coupler. The fl oater valve
automatically
closes after the maximum fi lling level
has been attained. (Refer to specifi c operating instructions
for information on operation of the metering unit) The
maximum service pressure
of the fl oater unit is 87 psi. (6 bar)
5.5.2 Empty the Solution Tank
Park vehicle such that the fi ll level hose (Fig. 8/3) is located
above the drain aperture in the fl oor. Take fi ll level hose
from holder and remove cap.
5.5.3 Cleaning Clear Water Filter
Check clean water fi lter (Fig. 8/4) at weekly intervals. Clean
or replace if required.
Only clean solution fi lter when the solution
tank is empty.
1. Empty solution solution tank (Fig. 8/1) see paragraph
5.5.2.
2. Unscrew fi lter cap.
3. Remove the fi lter element from the fi lter case for
cleaning. Replace if required.
4. Reinstall fi lter element and fi lter cap.