9.3. Trigger:
This screen is used to set the output behavior of your device. It has 2
parameters:
Delay: This parameter is used to define the delay between the last drop and
triggering of the flash or the camera. The unit is in milliseconds. For example, if
you set the delay to 100, the flash or camera will be triggered 100 milliseconds
later than the last drop.
Trigger Mode: This parameter is used to define which output will be triggered
after the last drop. You can select one of the two possible modes. The modes
are the “Flash” and the “Camera”. In the “Camera” mode, it will trigger the
camera after dripping the drop(s). In the "Flash" mode, it will trigger the
camera to start the long exposure before releasing the drop(s) and trigger the
flash after releasing the drop(s).
To Next Page
Loading...
