What causes low brine pump voltage in MIOX RIO H5 Portable Generator?
If your MIOX Portable Generator displays a 'Low Brine Pump Voltage' message, first check fuse F6 on the control interface board. Second, adjust the brine boost pressure to between 3-5 PSI if it's excessive. Third, verify the feed water meets system specifications if there are high Total Dissolved Solids (TDS) in the water.
Why does my MIOX RIO H5 Portable Generator have low cell voltage?
If the MIOX Portable Generator shows a 'Low Cell Voltage', first reset the large breaker (CB1) in the switch gear panel. Second, the contactor may have failed. Third, verify that the feed voltage meets the specification if the AC voltage feeding the system is low.
How to fix DA System Failure in MIOX RIO H5?
If your MIOX Portable Generator shows a DA System Failure, correct the external Dilution Air system failure. If an external Dilution Air system is not used, place jumpers across the input according to the wiring diagram.
How do I troubleshoot the diode temperature on my MIOX Portable Generator?
To address the diode temperature issue in your MIOX Portable Generator, first verify the cooling fan operation to ensure sufficient airflow to the transformer. Second, verify the operation of the current sensors to check for excessive current draw on the diode bank. Third, replace the temperature switch if it has failed.
Describes the proprietary membrane-less cell producing oxidants and its pressure reaction.
Crucial safety measures for installation, including codes, venting, and grounding.
Describes routing the power cable and connecting it to the switch gear compartment.
Details feed water requirements, pressure, and flow control for the OSG.
Step-by-step procedure for removing the OSG cell safely.
Step-by-step procedure for installing the OSG cell correctly.
Details how to connect cell leads to buss bars using electric joint compound.
Essential safety warnings for operating the OSG, including solution use and venting.
Steps for initial electrical check and filling the brine generator with salt.
Daily checks including salt level and initial operation monitoring.
Detailed steps for removing and installing a new brine pump.
Step-by-step instructions for safely removing the existing brine pump.
Procedures for safely replacing a ruptured rupture disk diaphragm.
Methods for preparing demand-free water essential for accurate testing.
Formulas to calculate daily chlorine production based on concentration and flow.
General| Brand | MIOX |
|---|---|
| Model | RIO H5 |
| Category | Portable Generator |
| Language | English |
To Next Page
