Mira Advance User Guide

11
1306246-W5-A
Basic Supply Checks
• Check there is electricity still supplied to the
appliance (lights and/or beeps will conrm this).
If in any doubt, contact a qualied electrician. If
a short power cut has occurred during use, the
shower will automatically reset and be ready
when the white start/stop light is illuminated.
Check all plumbing isolator valves to the shower
are fully open.
• A section of supply pipe is frozen. Allow to thaw
and insulate the pipe.
• Hot water may be retained within the shower
causing a failure to continue even though the
underlying cause may have been corrected. This
may be caused by a brief interruption to either
the electric or water supplies while the shower is
running, or incorrectly stopping the shower with
the isolator switch. Allowing the water to cool
or turning the shower on in full cold position to
remove any residual hot water before use should
clear this error.
Note! some hot water may ow from the showerhead
during this process, make sure that the showerhead is
pointing in a safe direction into the shower tray

Mira Advance Specifications

General

Temperature Control	Thermostatic
Warranty	2 Years
Power Ratings	9.8 kW
Water Connection	15 mm
Outlet Connection	1/2"
Water Pressure	0.7 - 10 bar
Cable Entry Points	Bottom entry
Safety Features	Overheat protection
Approvals	WRAS