Mira Advance User Guide

12
1306246-W5-A
Error Codes
Status
Indication
Flashing
Red
Flashing
No Water Flow
1. Check isolator valves
are fully open.
2. Check that the hose
/showerhead is not
blocked.
3. Isolate the electrical
supply at the pull cord
for a few seconds, turn
the shower to full cold
position,then re-apply
power and operate the
shower.
Start/Stop
Indication
Error
Code
Possible Cause
Rectication
A
Flashing
Red
Off B Flex Extra Models Only:
Incorrect Pump or Not
Paired
1. Check that the drain
pump is operational.
x1

Mira Advance Specifications

General

Temperature Control	Thermostatic
Warranty	2 Years
Power Ratings	9.8 kW
Water Connection	15 mm
Outlet Connection	1/2"
Water Pressure	0.7 - 10 bar
Cable Entry Points	Bottom entry
Safety Features	Overheat protection
Approvals	WRAS