13
1306246-W5-A
Note! If any of the button lights are ashing or pulsing
continuously (in excess of 15 seconds) this may indicate
that the button is stuck, this can be avoided by keeping the
unit clean.
There are a number of other Error Codes with different
light sequences. However, these are not user repair
error codes and you should contact your installer or refer
to the Support Section on the Kohler Mira website,
www.mirashowers.co.uk.
Flashing
Red/White
Flashing I
Incorrect Shutdown
1. Isolate the electrical
supply at the pull cord
for a few seconds, turn
the shower to full cold
position,then re-apply
power and operate the
shower.
2. Water pressure too low
or other outlets being
used while showering
causing a reduction
pressure.
3. Check isolator valves
are fully open.
4. Check that the hose
/showerhead is not
blocked.
To Next Page
Loading...
Need help?
General
