Mira Advance User Guide

9
1306246-W5-A
In the unlikely event that you experience problems with the
shower, then the following procedures will enable basic
troubleshooting before contacting a competent tradesperson
Warning! There are no user serviceable components
beneath the cover of the shower. Only a competent
tradesperson should remove the front cover. We recommend
any maintenance work is carried out by a Mira service
Engineer or similarly qualied tradesperson.
Reset the Shower
This is the rst solution to the shower not operating (See
below).
Isolate electrical supply.
1
The shower may have to automatically change the water ow
rate to achieve this. Inlet water temperatures, water pressure
and outlet temperature will all have an effect on ow rate.

Mira Advance Specifications

General

Temperature Control	Thermostatic
Warranty	2 Years
Power Ratings	9.8 kW
Water Connection	15 mm
Outlet Connection	1/2"
Water Pressure	0.7 - 10 bar
Cable Entry Points	Bottom entry
Safety Features	Overheat protection
Approvals	WRAS