13
9. Caution! It is essential at this
point that the supply pipework is
thoroughly ushed through before
connection to the bar valve.
10. Install the concealing plates,and
tighten the concealing plates until
they are ush with the nished wall.
11. Make sure that the sealing washer/
lter is tted, offer the bar valve up
to the offset connectors and tighten
the nuts.
Caution! Take care not to damage
the chrome plated surfaces.
12. Install the shower ttings.
13. Turn on the hot and cold water
supplies and check for leaks.
14. Before using the shower, refer to
section: ‘Commissioning’.
Sealing Washer/Filter
To Next Page
Loading...
Need help?
General
