38
Figure 18 FDX-008WKI Fan Damper Control Display Module
5.9.2 UUKL with FDX-008W and FDX-008WKI
The models FDX-008W and FDX-00WKI can be effectively used to provide an automatic and
manual control system for smoke. Refer to document number LT-966 for extensive instructions
regarding UUKL applications.
Note: There are also terminals located behind TS1 on the other side of the board for the
convenience of wiring the keyswitch. The last fan damper zone in the bottom right
position of the FDX-008WKI is controlled by the keyswitch.
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE
OFF AUTO ON TROUBLE OFF AUTO ON TROUBLE
TS1
P2
TERMINALS AT TS1 ARE WIRED TO A KEYSWITCH.
NOTE: IF FAN DAMPER MODULE IS MOUNTED TO
THE DOOR USE TERMINALS LOCATED AT THE
BACK OF THIS BOARD, BEHIND TS1.
P1
KEYSWITCH
CONTROLLED
CONNECTS TO
PREVIOUS DISPLAY
MODULE P2
To Next Page
Loading...