1
©Miri Technologies - www.miri.com.au - Telephone: (+61 8) 9409 8998, Fax: (+61 8) 9409 9229
30 Buckingham Drive. Wangara, WA 6065 Australia
1. Scope of this Manual
This manual is intended to provide sufficient information for the correct installation of your AD2006 telemetry
module. Your AD2006 module will be delivered pre-configured to your project specifications where requested, or set
to factory defaults as specified in this manual.
For programming information please refer to the MiriMap 2000+ Software on-line help.
2. Ordering Information
There are many variations of the AD2006 telemetry modules available. The following shows the ordering code and
details for modules with or without internal data radios. For other radio or modem options please contact Miri
directly.
The following options are not fitted as factory standard and need to be requested when ordering;
• 4 Channel Analog Output Option
• Ethernet Port Option
Please Note: If you are ordering a module to add to an existing
system, please be sure to specify the project name when
ordering the new module.
The AD2006 part number is displayed on the rear of each unit
together with other relevant information.
Part Numbers / Ordering Code
To Next Page
Loading...
Need help?
General
