12 Mirka® DEROS • 125 mm (5") & 150 mm (6") • 110 V
Replacing the backing pad
1. Insert the pad wrench between the backing pad and brake seal to hold the spindle nut.
2. Turn the backing pad counterclockwise to remove it.
3. Fit and tighten the new backing pad with two washers.
4. Remove the pad wrench.
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and
continuously with net products. These cost effective pad savers, placed between the backing pad and the sanding disc,
should be changed regularly. The pad savers prolong the life of the backing pad.
http://www.mirka.com/accessories/Pad_Savers/#/
Always disconnect the power before maintenance!
Only use original Mirka spare parts!
Maintenance
en
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to an App from which additional
tool functionality can be accessed. For more information on the App functionality and if it is available in your country,
go to www.mirka.com.
Activate Bluetooth on your Mirka® DEROS as follows:
1. Connect the power cord to mains outlet.
2. Press and hold the + button while switching the tool on with the On/Off button.
3. Left LED lights up (green), to indicate that Bluetooth is active.
4. Bluetooth is deactivated when the tool is disconnected form mains outlet.
NOTE! If the App is not installed or if it is not available in your country, Bluetooth shall not be activated.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by KWH Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Compliance with the radio regulations in North America has been verified in accordance with FCC Part 15 subpart
B and C, RSS-GEN, RSS-247 and FCC §15.247.
To Next Page
Loading...
