14 Mirka® DEROS • 125 mm (5") & 150 mm (6") • 110 V
Reducing vibrations when sanding with pad saver or interface
When a pad saver or interface is used for sanding, the set-up may increase the level of vibrations. Your Mirka tool has a
feature allowing you to reduce these vibrations. To reduce vibrations that may appear when a pad saver or interface is
used, please follow these steps:
1. Disconnect power cable.
2. Remove backing pad.
3. Add hex nuts and screws in accordance with the table below, tighten to 2 Nm.
Example
Model Picture Set-up out of box
Screw Hex nut
A B C D E A B C D E
550 1 – X X – – – – – – –
625 1 – X X – – – – – – –
650 1 – X X – – – – – – –
680 3 – X – X X – – – – –
5650 1 – X X – – – – – – –
Model Picture Set-up for padsaver / interface
550 2 X X X – – X X X – –
625 2 – X X – – – X X – –
650 2 X X X – – X X X – –
680 4 X X X X X – – – – –
5650 2 X X X – – X X X – –
1. Machine configuration out of box.
3. Machine configuration out of box.
2. Machine configuration for use with pad saver or interface.
4. Machine configuration for use with padsaver or interface.
en
To Next Page
Loading...
