EasyManua.ls Logo

Miroir MP60 - Product Compliance and Battery Safety; Rechargeable Battery Precautions; FCC Compliance Information

Miroir MP60
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WARNING!
This ProducT conTains a rechargeable baTTery
Do not store this product in high temperatures, damp areas or in •
direct sunlight.
Never disassemble the product.•
Never dispose of the product in re or water, which may result in •
explosion and/or injury.
Keep product out of reach of children.•
Do not touch product with damp hands.•
Dispose of the product properly.•
The product must not be discarded with ordinary household waste.•
Contact your local recycling center for proper disposal.•
FCC INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.1)
This device must accept any interference received including interference 2)
that may cause undesired operation.
Warning:
Changes or modications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This unit generates, uses, and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment o and
on, the user is encouraged to try and correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment to an outlet on a circuit dierent from that to which •
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.•
5 6
Shielded cables must be used with this unit to ensure compliance with the Class
B FCC limits.

Related product manuals