5312/5324 IP Phones User Guide
- 36 -
Before locking a set, ensure that
• the set is in the idle state (there should not be any ongoing call)
• you do not have any calls on hold or on consultation-hold on any line appearance
• you are not in headset mode
To activate Phone Lock:
• Press the Phone Lock feature key or enter the Phone Lock Feature Access code.
To de-activate Phone Lock:
• Press the Phone Lock feature key or enter the Phone Unlock Feature Access code.
• Enter your user PIN to unlock the set.
Note: If a user PIN has not been assigned, enter # when prompted for the PIN to unlock
the phone.
User PIN (5324 IP Phone only)
A Personal Identification Number (PIN) allows a user to log into a set as a hot desk user or
generic SIP user. It is also used to de-activate the Phone Lock feature. PINs must be from 0
to 8 digits in length. Only digits (0 to 9) are permitted. The default PIN is blank (length zero).
Users will have one generic PIN that can be used for any required features.
The User PIN initially has a zero length, allowing a user, for example, to unlock a phone
using a blank PIN for Phone Lock. Setting the User PIN on the set requires the PIN to have at
least one digit.
To change the User PIN:
1. Press
(MENU).
2. Press No until "Set User PIN?" appears.
3. Press Yes softkey or the User PIN softkey.
4. At the prompt "Enter Old PIN", enter your old User PIN.
5. Press Enter.
6. At the prompt "Enter new PIN", enter your new PIN.
Use left arrow key to correct mistakes. The PIN can include digits from 0 to 9 only
and can be from 0 to 8 characters in length.
7. Press Enter.
To Next Page
Loading...
Need help?
General
