Operation and Maintenance
Event message Trigger condition
Details
63
Severity
• PRI, BRI and DSI cards
do not have temperature
sensors and are therefore
never deactivated due to
overheating.
Overload detected
on USB port (CPU2)
(Mitel 470 only)
A (current) overload was detected
on one of the USB interfaces on
the applications card (CPU2).
Note:
The maximum current input
at the USB interfaces varies.
Date, time Normal (without
match)
Port out of service A port previously in operation has
stopped functioning.
Number of the
slot, relevant port
number, date, time
Serious (without
match)
Possible clone
detected for your
system (Virtual
Appliance only)
The clone detection service on
the licence server (SLS cloud) has
detected a possible clone (system
with the same EID).
Date, time critical (negative,
with match)
QSIG licence limit
reached
Maximum number of licensed
outgoing connections with QSIG
protocol exceeded
Route number,
user number, date,
time
Serious (without
match)
Radio unit port active The radio unit is responding again Card number, port
number, date, time
Serious (positive,
with match)
Register error • Card not fitted
• Card not logged on
• Card defective
Card number,
date, time
Normal (without
match)
63
The node is also always indicated in an AIN.
Release 7.1
System Manual for Mitel SMB Controller 240
To Next Page
Loading...
Need help?
General
