1
Leaflet installation Mitel UC360
A. Overview
This document describes how to integrate a Mitel UC360 device in the PBX.
The integration can only be done by a system administrator with special administration
rights!
The Mitel UC360 will be installed as an unprovisioned SIP device. Be aware, that there
is no support nor guarantee for unprovisioned SIP devices.
B. Requirements
The Mitel UC360 system software (Firmware) has been tested with the version 2.0.1.9
Detailed description how to upgrade the system software of the Mitel UC360 can be found in the
official Mitel documentation:
UC360_Admin_R1.0_SP2.pdf
UC360 Configuration
Upgrade System Software
C. Portal settings
This section describes the first steps, how to insert and administrate a Mitel UC360 as a SIP
unprovisioned device.
SIP accounts will be registered on the administration portal as unprovisioned SIP device
by the support team. You will find the SIP accounts under Elements / Devices. Please
contact the support team.
No. Description Picture
1. Please enter the portal.nfon.com with your userID and password.
To Next Page
Need help?
General
