Mitel Superset 4025 User Manual

-1-
ABOUT YOUR PHONE
The SUPERSET 4025 phone has ten fixed-function keys ( SUPERKEY,
TRANS/CONF, REDIAL, MESSAGE, HOLD, CANCEL, SPEAKER,
MICROPHONE, and ) three softkeys, and 14 personal keys with built-in
status indicators. The personal key on the bottom right is always your Prime
Line; the remaining personal keys can be programmed as:
! Feature keys (for example, Swap ). You can program feature keys from
your phone. Your administrator can also program feature keys.
! Speed Call keys. You can program speed call keys from your phone.
! Line Appearances. Only the administrator can program line appearances.
Your telephone also features display-assisted selection of features, on-hook
dialing, and a large Message Indicator.
Note: When using the SUPERKEY, press CANCEL to back up one menu
level.
IMPORTANT NOTE FOR HEADSET USERS:
Headsets with a feature control switch that are approved for use with the
SUPERSET 4025 telephone must be installed in the dedicated headset jack
(the jack nearest the front of the phone). Installation will disable your
handset microphone. Disconnecting the headset at the jack or at the quick-
disconnect plug restores handset operation.
Telephone status indicators
When line is: the indicator is:
Idle Off
Busy On
Ringing Flashing slowly
On hold at your phone Flashing rapidly
On hold at another phone Flashing slow on/fast off

Mitel Superset 4025 Specifications

General

Speakerphone	Yes
Headset Jack	Yes
Line Keys	2
Type	Digital
Compatibility	Mitel communications systems
Display	2-line, 24-character LCD