Learning to Use the FX Family for Positioning Control FX3U-20SSC-H positioning
4 - 64
MITSUBISHI ELECTRIC
Writing data to the FX3U-20SSC-H
Write the servo parameters, positioning parameters and table information to the FX
3U
-20SSC-H BFM
and Flash ROM by pressing the
Write to module
button and placing check marks in the following
boxes. Change the range of table data to be written to 0–25.
Next, reset the module by pressing the
System reset
button. This is necessary to refresh the
servo parameters.
Fig. 4-45: Write to module
window
To Next Page
Loading...
