FX2N-10GM and FX2N-20GM positioning Learning to Use the FX Family for Positioning Control
FX Positioning Control Systems 4 - 57
Below are the four positioning parameter windows from VPS. The settings on these windows should
be copied for BOTH the X- and Y- axes before performing positioning.
Open the "Parameter Units" window by selecting
Parameters
Positioning
Units
from the
main menu bar at the top of the screen.
Open the
Parameter Speed
window by selecting
Parameters
Positioning
Speed
from
the menu bar at the top of the screen.
The
Max speed
is set very low in order for the VPS software to trace the path during operation
through the
Monitoring
window. In turn, both the JOG speed and interpolation value must be
reduced. (In practice, it is impossible to have the JOG speed set to a value higher than the Max
speed setting.)
Fig. 4-37:
Parameter Units
window
Fig. 4-38: Parameter Speed
window
452040da.eps
Specify the same settings
for the Y-axis
452050da.eps
Specify the same settings
for the Y-axis
To Next Page
Loading...
