34
6 OPERATION EXAMPLES
6.2 Program Examples
Label settings
GX Works3 provides functions that support the creation of a program.
The following table lists the module labels and global labels used for the program examples in this section.
There is no need to change the settings of the module labels. For details on the global labels, refer to the following.
MELSEC iQ-R Programming Manual (Program Design)
Classification Label name Description Device
Module label R60TDG_1.bModuleREADY Module READY X0
R60TDG_1.bDisconnectionDetectionSignal Disconnection detection signal XC
R60TDG_1.bConversionCompletedFlag Conversion completed flag XE
R60TDG_1.bErrorFlag Error flag XF
R60TDG_1.bOperatingConditionSettingRequest Operating condition setting request Y9
R60TDG_1.stnMonitor[0].wMeasuredTemperatureValue CH1 Measured temperature value
R60TDG_1.uConversionCompletedFlag.0 CH1 Conversion completed flag
R60TDG_1.stnMonitor[2].wMeasuredTemperatureValue CH3 Measured temperature value
R60TDG_1.uConversionCompletedFlag.2 CH3 Conversion completed flag
R60TDG_1.stnMonitor[4].wMeasuredTemperatureValue CH5 Measured temperature value
R60TDG_1.uConversionCompletedFlag.4 CH5 Conversion completed flag
R60TDG_1.stnMonitor[6].wMeasuredTemperatureValue CH7 Measured temperature value
R60TDG_1.uConversionCompletedFlag.6 CH7 Conversion completed flag
R60TDG_1.uWarningOutputFlagProcessAlarmUpperLimit.2 CH3 Alert output flag (Process alarm upper limit)
R60TDG_1.uWarningOutputFlagProcessAlarmLowerLimit.2 CH3 Alert output flag (Process alarm lower limit)
R60TDG_1.uWarningOutputFlagRateAlarmUpperLimit.0 CH1 Alert output flag (Rate alarm upper limit)
R60TDG_1.uWarningOutputFlagRateAlarmLowerLimit.0 CH1 Alert output flag (Rate alarm lower limit)
R60TDG_1.uDisconnectionDetectionFlag.6 CH7 Disconnection detection signal
Labels to be defined Define global labels as shown below:
To Next Page
Loading...
