Mitsubishi Electric MELSEC iQ-R Series - Entire Process of Introduction

5
1 OVERVIEW
1.1 Entire Process of Introduction
1.1 Entire Process of Introduction
Follow the steps below to configure and check the operation. For details, refer to Chapter 2 and later in this document.
Network camera setting
Preparation
Programmable controller setting
Do preparation such as wiring devices and inserting an SD memory card.
Chapter 2
Chapter 4
Chapter 3
Operation example
Chapter 9
GOT setting
Configure the settings on the GOT to sample resource data.
Chapter 5
Recording
Execute the program and read the recording file.
Chapter 6
Checking the recorded recording file
Open the read recording file, and monitor the program operation offline.
Chapter 7
Configure the settings for connecting the network camera and programmable
controller, and configure the settings for recording and saving videos.
Configure the settings of the programmable controller to use the recording
function of the camera recorder module.
Investigate and analyze the cause of the error by using videos recorded
with cameras, the offline monitor function of GX Works3, data flow analysis,
and GX LogViewer.