Mitsubishi Electric melsec q03ud(E)cpu - Operating the Program in the Memory Card (Boot Operation)

5 - 23
CHAPTER5 MEMORIES AND FILES USED FOR CPU MODULE
1
2
3
4
5
6
7
8
5.1 Memories Used for CPU Module 5.1.8 Operating the program in the memory card (boot operation)
5.1.8 Operating the program in the memory card (boot operation)
This section describes methods for operating the program stored in the memory card.
(1) Operating the program in the memory card
To operate the program stored in the memory card, make setting so that the program is booted to the program
memory after the CPU module is powered off and then on or is reset. ( (3) in this section, (4))
The program whose file name is specified in the Boot file tab is booted from the memory card to the program
memory after the CPU module is powered off and then on or is reset.
(2) Bootable files, transfer source, and transfer destination
Table Table5.5 provides the combinations of bootable file, transfer source, and transfer destination.
: Bootable, : Cannot be booted.
Figure 5.20 Boot operation
Table5.5 Combinations of bootable file, transfer source, and transfer destination
Filename Transfersource
Transferdestination
Programmemory StandardROM
Parameter
Memory card
Sequence program
Device comment
Initial device value
Label program
CPU module
Memory card
Boot
Program
memory