Mitsubishi Electric melsec q03ud(E)cpu - 8.2 Network Parameters

8 - 20
CHAPTER8 PARAMETERS
1
2
3
4
5
6
7
8
8.2 Network Parameters
8.2 Network Parameters
This section provides the list of network parameters and describes parameter details.
Symbols, M and N, used in the "Parameter No." column
M and N in "Parameter No." in this section denote the following:
•N: FIndicates the module number.
•M: FIndicates the network type.
Table8.14 For CC-Link IE controller network and MELSECNET/H ( (1), (2) in this section)
M Networktype
1
H
CC IE Control (Control station), MELSECNET/H mode (Control station), MELSECNET/H
Extended mode (Control station), MELSECNET/10 mode (Control station)
2H
CC IE Control (Normal station), MELSECNET/H mode (Normal station), MELSECNET/H
Extended mode (Normal station), MELSECNET/10 mode (Normal station)
5H
MELSECNET/H (Remote master)
AH
MELSECNET/H (Standby station)
BH
MELSECNET/H mode multiplexed remote I/O network master station
DH
MELSECNET/H mode multiplexed remote I/O network sub-master station
(when no parameter is set)
EH
MELSECNET/H mode multiplexed remote I/O network sub-master station
(when parameters are set)
Table8.15 For CC-Link setting ( (4) in this section)
M Networktype
0
H
Master station
1H Local station
2
H Standby master station