6 - 94
(b) Setting “After conversion writing behavior” and “Step No. specification used in writing”
Set them as follows:
1) Select "Write during RUN (while PLC is running)" in “After conversion writing behavior”.
2) Select “Absolute step No. (default)” or “Relative step No. by pointer” in “Step No. specification used in
writing”.
(c) Performing Write during RUN
Display the ladder including the specified pointer and write the changed ladder during RUN.
(3) Precautions
Precautions for Write during RUN from multiple GX Developers are the same as those for usual Write during RUN
( Section 6.12.3).
To Next Page
Loading...
