3 - 1
3. SPECIFICATIONS
3 SPECIFICATIONS
The general specification common to various modules is shown.
*1 This indicates the section of the power supply to which the equipment is assumed to be
connected between the public electrical power distribution network and the machinery within
premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
*2 This index indicates the degree to which conductive material is generated in terms of the
environment in which the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity
caused by condensing must be expected occasionally.
*3 Do not use or store the programmable controller under pressure higher than the atmospheric
pressure of altitude 0m. Doing so may cause malfunction. When using the programmable
controller under pressure, please consult your local Mitsubishi Electric representative.
Item Specifications
Operating ambient
temperature
0 to 55
Storage ambient
temperature
-20 to 75
Operating ambient
humidity
10 to 90 % RH, No-condensing
Storage ambient
humidity
Vibration resistance
*4
Compliant
with JIS B
3502, IEC
61131-2
Frequency
Constant
acceleration
Half amplitude Sweep count
Under
intermittent
vibration
5 to 9 Hz
–
3.5mm 10 times each
in X, Y, Z
directions.
9 to 150 Hz
9.8m/s
2
–
Under
continuous
vibration
5 to 9 Hz
–
1.7mm
–
9 to 150 Hz
4.9m/s
2
–
Shock resistance
Compliant with JIS B 3502 and IEC 61131-2 (147 m/s
2
, 3 times each in 3 directions X, Y, Z)
Operating atmosphere No corrosive gases
Operating altitude
*3
0 to 2000m
Installation location Inside a control panel
Overvoltage category
*1
II or less
Pollution degree
*2
2 or less
Equipment class Class I
To Next Page
Loading...
