132
*1 When leaving a cable connected to a USB connector or RS-232 connector, clamp the cable.
The Q6HLD-R2 type RS-232 connector disconnection prevention holder is available as a clamp for the RS-232
connector.
*2 Operate the RUN/STOP/RESET switch with your fingertips.
To prevent the switch from being damaged, do not use any tool such as screw driver.
17) Battery connector pin
For connection of the battery lead wires.
(Lead wires are disconnected from the connector when shipping to prevent the battery from
consuming.)
18)
USB connector
*1
Connector for connection with USB-compatible peripheral devices. (Connector type miniB)
Can be connected by USB-dedicated cable.
19)
RS-232 connector
*1
Connector for connecting a peripheral device by RS-232.
Can be connected by RS-232 connection cable. (QC30R2)
20)
RUN/STOP/RESET switch
*2
RUN: Executes sequence program operation.
STOP: Stops sequence program operation.
RESET:
Performs hardware reset, operation error reset, operation initialization or like.
(
Page 182, Section 6.4.1)
No. Name Application
Fixing screw
Q6HLD-R2
CPU module
RS-232 cable
To Next Page
Loading...
