EasyManua.ls Logo

Mitsubishi Electric Q13UDVCPU - Page 440

Mitsubishi Electric Q13UDVCPU
720 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
438
4A00
H
Link-related
error
Access to the specified station cannot be
made since the routing parameters are not set
to the start source CPU module and/or relay
CPU module.
For routing via a multiple CPU system, the
control CPU of the network module for data
routing has not started.
When System A/System B is not yet identified
in a redundant system configuration,
communication was made with the other
station via the network module.
The Built-in Ethernet port QCPU or the Built-in
Ethernet port LCPU that performs IP packet
transfer is not the control CPU of the CC-Link
IE module, which is on the path that an IP
packet takes.
Set to the related stations the routing
parameters for access to the specified station.
Retry after a while, or start communication after
confirming that the system for data routing has
started.
In a redundant system configuration, connect
the tracking cable, start System A/System B
normally, and then restart communication.
Set the Built-in Ethernet port QCPU or the Built-
in Ethernet port LCPU that performs IP packet
transfer as the control CPU of the CC-Link IE
module, which is on the path that an IP packet
takes.
QCPU
LCPU
The network of the No. set to the routing
parameters does not exist.
The specified CPU module cannot be
communicated through the network that is not
supported by the CPU module.
Check and correct the routing parameters set to
the related stations.
Set communication through the network that is
supported by the specified CPU module.
QnUDV
4A01
H
Link-related
error
The network of the No. set to the routing
parameters does not exist.
The specified CPU module cannot be
communicated through the network that is not
supported by the CPU module.
Check and correct the routing parameters set to
the related stations.
Set communication through the network that is
supported by the specified CPU module.
QCPU
LCPU
4A02
H
Link-related
error
Access to the specified station cannot be made.
Check the network module and the data link
module for error or check that the modules are
not in offline.
Check to see if the network number/PC number
setting has no mistake.
QCPU
LCPU
4A03
H
Link-related
error
A request for network test was issued. Check the request data of the MC protocol, etc.
QCPU
LCPU
4A04
H
Link-related
error
A request is executed to the CPU module which
does not support all stations specification.
Replace the CPU module to the one which
supports all stations specification.
Execute the request to the CPU module which
supports all stations specification.
QnUDV
4A20
H
IP
communication
test related
error
The upper 2 bytes of the IP addresses do not
match between a CPU module and the
request destination device on the same path
that an IP packet takes.
The upper 2 bytes of the IP addresses do not
match between a CPU module and a CC-Link
IE module on the same path that an IP packet
takes.
The upper 2 bytes of the IP addresses do not
match between CC-Link IE modules on the
same path that an IP packet takes.
The upper 2 bytes of the IP addresses do not
match between the request source device and
the CPU module connected to the request
destination device by Ethernet.
Check and correct the IP address settings of the
built-in Ethernet ports of the CPU module.
Check and correct the IP address of the request
destination device.
Check and correct the IP address of the CC-Link
IE module.
Check and correct the IP address of the request
source device.
QCPU
LCPU
4A21
H
IP
communication
test related
error
The 3rd byte (Network No.) or 4th byte (Station
No.) of the IP address of the CPU module is
the number that is not available for CC-Link IE.
The 3rd byte (Network No.) or 4th byte (Station
No.) of the IP address of the request
destination device is the number that is not
available for CC-Link IE.
Check and correct the IP address settings of the
built-in Ethernet ports of the CPU module.
Check and correct the IP address of the request
destination device.
QCPU
LCPU
Error code
(Hexadecimal)
Error item Error details Corrective action
Corresponding
CPU

Table of Contents

Related product manuals