Mitsubishi Electric Q13UDVCPU - Page 448

446
C055
H
iQ Sensor
Solution related
error
System error
• Check the operating status and connection
status of each device supporting iQ Sensor
Solution.
• Check the connection status of each Ethernet
cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and devices supporting
iQ Sensor Solution, and execute the function
again.
• If the same error code is displayed again even
after the above actions are taken, please consult
the manufacturer of the device supporting iQ
Sensor Solution.
QnUDV
LCPU
C056
H
iQ Sensor
Solution related
error
System error
• Check the operating status and connection
status of each device supporting iQ Sensor
Solution.
• Check the connection status of each Ethernet
cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and devices supporting
iQ Sensor Solution, and execute the function
again.
• If the same error code is displayed again even
after the above actions are taken, please consult
the manufacturer of the device supporting iQ
Sensor Solution.
QnUDV
LCPU
C059
H
iQ Sensor
Solution related
error
The function not supported by the target device
supporting iQ Sensor Solution was executed.
Check the version of the device supporting iQ
Sensor Solution.
QnUDV
LCPU
C05C
H
iQ Sensor
Solution related
error
• The communication setting value is out of the
range.
• The communication setting item not supported
by the target device supporting iQ Sensor
Solution is set.
• The setting item required for the target device
supporting iQ Sensor Solution is not set.
Review the settings, and execute the function
again.
QnUDV
LCPU
C061
H
iQ Sensor
Solution related
error
System error
• Check the operating status and connection
status of each device supporting iQ Sensor
Solution.
• Check the connection status of each Ethernet
cable and the hub.
• Check the line status of Ethernet.
• Reset the CPU module and devices supporting
iQ Sensor Solution, and execute the function
again.
• If the same error code is displayed again even
after the above actions are taken, please consult
the manufacturer of the device supporting iQ
Sensor Solution.
QnUDV
LCPU
C080
H
MELSOFT
connection
extended
setting related
error
The target IP address is not obtained in
MELSOFT connection extended setting.
Set the station number <-> IP information to the
CPU module.
QnUDV
C086
H
MELSOFT
connection
extended
setting related
error
A received message exceeds the receptible size.
Correct the size of the send message of request
source.
QnUDV
Error code
(Hexadecimal)
Error item Error details Corrective action
Corresponding
CPU